Laces of necktie

Simple Tie

Preparation: Turn up the collar of his shirt, close the reset button andtie.
Middle-class men put the small part of the tie at the waist. Men withshort busts prefer the double knot whose shape is similar.

Steps:
Step 1: Below the neck, across the wide part of the narrow part just below the neck.
Step 2: Slip below the wide portion of the narrow part.
Step 3: Fold the wide end over the narrow end.
Step 4: Pass the wide end over the tie after placing her finger on the knot that is forming. Removing the finger and slide the wide partinside the knot.
Step 5: Hold the narrow end, then gently pull the wide end to closethe knot. Adjust the knot, then upload it to the last button of the neck.

Once the knot is made, the narrow part should not be seen and the tip of the wide part should be at waist level

Doble Tie
Preparation: Slide the tie around the neck after having closed the last button and raised the collar of his shirt.
The two sides of the tie is placed asymmetrically. The widest part is left longer than the narrowest part of the tie.

The double knot in 4 stages:
Step 1: Below the neck, pass the first time the wide part of the narrow environment (see step 1 to 3 knot).
Step 2: Pass a second time the broad side of the narrowenvironment.
Step 3: Lift the wide end up below the tie and slide the knot formed by the first or second rotation.
Step 4: Finally you adjust knot obtained, upload and center in the middle of the neck.

 Windsor Tie

Preparation: Slide the tie around the neck after having closed the last button and raised the collar of his shirt.
The two sides of the tie is placed asymmetrically. The widest part is left longer than the narrowest part of the tie.

The double knot in 4 stages:
Step 1: Below the neck, pass the first time the wide part of the narrow environment (see step 1 to 3 knot).
Step 2: Pass a second time the broad side of the narrowenvironment.
Step 3: Lift the wide end up below the tie and slide the knot formed by the first or second rotation.
Step 4: Finally you adjust knot obtained, upload and center in the middle of the neck.

  HalfWindsor Tie

Preparation: Place the tie around the neck. The middle class willnarrow part of the tie well above the waist.

The Half Windsor is done in 4 stages:
Step 1: Cross the wide end over the narrow end. Keep the crossing,and next, to buckle up the wide end under the tie and pulling it out.
Step 2: Pass the wide horizontally behind, then past the narrow part.
Step 3: Holding the junction, pass the wide vertically under the tie and slide it into the buckle.
Step 4: Hold the narrow end. Pull the wide end to form the knot.Slide to the last button of his shirt collar and center.

At the end of the knot, the narrow part should not be seen and the tip of the wide part should be at waist level

Small Tie

Preparation: Put your tie on the right and walk around the wide partof 180 degrees (see diagram above) or to avoid "plait", simply slideyour tie around the neck backwards. The wide part is left longer than the narrow part.

The realization of a small loop occurs in 4 stages:
Step 1: Under the neck, place the wide end under the narrow end.
Step 2: Pass the wide end immediately above the narrow end.
Step 3: Keep the buckle from the wide end under and up. Pull the wide end and slip it into the buckle.
Step 4: Finally, tie the knot to tie and then upload.

For that perfect knot, the top button of his shirt and narrow part of the tie should hide